Remap Falloff

Summary

The Remap Falloff transforms existing falloff attribute values using various remapping techniques including range fitting, clamping, inversion, absolute values, and custom curve-based transformations. Essential for fine-tuning and adjusting falloff patterns created by other falloff operators.

Supports automatic or manual input range detection, custom output ranges, and optional custom ramp curves for non-linear transformations. You can clamp values to specific ranges, invert falloff patterns, or apply absolute values for symmetrical effects.

The remapped results can be written to the same attribute or a different one, and previewed with color ramps for visual feedback. This makes Remap Falloff a powerful post-processing tool for refining falloff values to match specific artistic or technical requirements.

Parameters

Page: Remap

Group Group – If there are input groups, specifying a group name in this field will cause this POPX to act only upon the group specified.
Input Attribute Inputattr – Name of the falloff attribute to read values from for remapping.
Output Attribute Outputattr – Name of the attribute to write the remapped falloff values to.
Clamp Clamp – When enabled, constrains falloff values to the 0-1 range.
Fit Fit – Enables remapping of falloff values from an input range to an output range.
Auto Input Min Max Auto – Automatically determines input range from actual min/max falloff values.
Input Min Inputmin – Minimum value of the input range for remapping.
Input Max Inputmax – Maximum value of the input range for remapping.
Output Min Outputmin – Minimum value of the output range for remapping.
Output Max Outputmax – Maximum value of the output range for remapping.
Absolute Value Absvalue – Converts all falloff values to their absolute values (positive only).
Invert Invert – Reverses the falloff values (1 - value).
Enable Remap Ramp Enableremapramp – Applies a custom curve defined by a ramp to remap the falloff values.
Open Remap Ramp Openremapramp – Opens the ramp editor for defining the custom remapping curve.
Reset Remap Ramp Resetremapramp – Resets the remap ramp editor.
Remap TOP Remaptop – Reference to an external TOP for remap control. When specified, overrides the internal ramp editor.

Page: Falloff

Preview Falloff Previewfalloff – When enabled, visualizes falloff values using a color ramp.
Falloff Ramp Fallofframp – – Color ramp preset used for visualizing falloff values when Preview Falloff is enabled.
Heatmap heatmap
Blackbody blackbody
Infrared infrared
Custom custom
Open Custom Ramp Opencustumramp – Opens the custom color ramp editor for defining a custom falloff visualization gradient.
Reset Custom Ramp Resetcustomramp – Resets the custom color ramp to its default state.

Page: Common

Bypass Bypass – Pass through the first input to the output unchanged.
Free Extra GPU Memory Freeextragpumem – Free memory that has accumulated when output memory has grown and shrunk.
Render Primitives Renderprimitives – Toggles rendering of POPX Geometry or shows it as point instances only.
SRT / RST Srtrst – Sets the transform order when using POPX Geometry as built-in TouchDesigner instances.

Inputs

Input 0 POP – POPX/POP Geometry

Outputs

Output 0 POP – POPX_out1